Positioning in relation to the channels in the foam filling

Fig 1: Identifying End Of The Pad Not Up On Flat Surface

Courtesy of VOLVO CARS OF NORTH AMERICA.

• If the heater pad terminates at the channel, position it as illustrated.
  NOTE:

  The end of the pad must not be up on the flat surface.

Fig 2: Identifying Proper Pad Fill Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

• If the pad and/or wire in the heater pad is to be positioned in the channel, the pad must follow the foam filling as illustrated. Failure to do so may result in loads to the pad and/or wire that damage the pad. (The type of seam on the upholstery may cause wear in the long term).