Checking input signal
When the seat is operated there should be a pulsed signal between pins according to the table.
| DTC | Component | Terminal | Connector |
| PSM-003A | Hall sensor 1 | #3, #4 | E |
| PSM-003B | Hall sensor 2 | #3, #4 | D |
| PSM-003C | Hall sensor 3 | #7, #8 | E |
| PSM-003D | Hall sensor 4 | #11, #12 | E |
Other information:
- To connect the breakout box, see Connecting the breakout box, power seat module (PSM) .
- For information on signals, refer to Output signals to the motors .