Seat Belt Tensioner, Checking

The illustrations in this service information are used for different model years and / or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Checking the seat belt tensioner

CAUTION:

When replacing deployed seat belt tensioners, seat belt buckles and end mountings must always be replaced.

Seat belt tensioners can be checked in two different ways:

Check for any diagnostic trouble codes (DTCs) using VIDA
Physical check as follows.

NOTE:

Third row seat belt tensioners cannot be checked physically, only via VIDA.

Fig 1: Identifying Piston Positions

Courtesy of VOLVO CARS OF NORTH AMERICA.

Insert a wire in the pipe on the seat belt tensioner as illustrated.

Check the piston position in the seat belt tensioner.

Piston position A:

The seat belt tensioner has deployed. Replace both the seat belt (inertia) reels and the seat belt tensioners. See Seat belts, replacing .

Piston position B:

The seat belt tensioner has not deployed. No corrective action is required.

NOTE:

If any airbag has deployed, all seat belts and tensioners must be replaced.