Installing the front bumper

Fig 1: Aligning Lugs On Bumper In Channels On Slide Mounting

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the quick-release connector for the headlamp washer
• the 2 connectors for the fog lamps.

Guide the lugs (3) in to the grooves on the side bracket (4).

Press at the top so that the lugs engage.

Press in the bumper cover as far as it will go.

HINT: This operation is easier with two people. 

Fig 2: Identifying Bumper Cover Clips

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the 2 x M8 screws. Tighten
• the 6 clips, on the upper side of the casing
• the 2 clips (5) on the underneath of the bumper
• the trim strip on the left and right-hand sides
• the screw (1), 1 per side. Tighten.