Installing brackets

Fig 1: Identifying M5 Rivet Nut Installation

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install 2 M5 rivet nuts on each side. Use special tool

NOTE: Install the M5 screws in the rivet nuts. Apply high viscosity rust-proofing agent, P/N 951 0226, to the screws.

NOTE: Remove the M5 screws.

Fig 2: Identifying Bracket, Screws And Flat Washers

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the bracket. Use 2 x M5 screws and the flat washers from the kit.

Fig 3: Identifying Joint Protection Installation

Courtesy of VOLVO CARS OF NORTH AMERICA.

Tighten the screws. See Tightening torque .

Install the joint protection, P/N 912 8331, on the rivet nut which protrudes under the electrical unit.