Connecting breakout box: Connecting

• Ignition off
• Remove the door panel
• Disconnect the module connectors.
  NOTE: Disconnect the 12-pin connector before the 30-pin connector.

Connect the adapter to the control module connector. Connect breakout box 9511428 . Connect wiring 9511499 to the adapter.

Adapter wiring 9511507 is for the 12-pin connector. Adapter wiring 9813194 is for the 30-pin connector.

Disconnect the breakout box in reverse order.

Other information 

• To remove the door panel, see Panel, front side door, replacing (-2003) or Panel front side door, replacing (2004-)
• For further information about signals and other values, see Signal specification .