Checking component

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that the fuses for the RTI (road traffic information) and audio control module are intact. The fuses are located in the passenger compartment and the cargo area fuse boxes
Ignition on.
Measure the voltage between terminals #K1 and #K5. Voltage must be approximately 12 V.

Measure the voltage between terminals #K2 and #K5. Voltage must be approximately 12 V.

Measure the voltage between terminals #K3 and #K4. Voltage must be approximately 12 V.

Check the cable between display screen terminal #J4 and control module terminal #C4. Check for a short-circuit to supply voltage. Check for a short-circuit to ground. Check for an open-circuit.

Remedy as necessary.

Other information:
- To access and replace the fuses, see, Fusebox, passenger compartment, replacing
- To fault-trace wiring and terminals, see Checking wiring and terminals
- To access and replace the display screen, see Display screen / loudspeaker, RTI (road traffic information), replacing
- For information about programming and replacing the road traffic information (RTI) control module, see Road traffic information module (RTI), replacing
- To connect the breakout box, see Connecting the breakout box to the Road Traffic Information (RTI) control module
- For information about signals and connectors, see Signal specification, RTI .
Fig 2: Identifying Breakout Box
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Ohmmeter
Courtesy of VOLVO CARS OF NORTH AMERICA.

Was a fault detected?