Installing the DVD reader

Fig 1: Identifying Tie Straps

Courtesy of VOLVO CARS OF NORTH AMERICA.

Secure the cable harness at the cable duct using two tie straps (1)
Secure the excess blue connector together with the cable harness connected to the fuse holder at the cable harness for the fuse holder. Use a tie strap (2).

Applies to cars with a CD changer

Fig 2: Cable Harnesses And Ties

Courtesy of VOLVO CARS OF NORTH AMERICA.

Secure the cable harness at the cable duct using two tie straps (1)
Secure the cable harness connected to the fuse holder at the cable harness to the fuse holder using a tie strap (2)
Route the cable (3) with the blue connector. Position the cable at the tail lamp. The cable will be connected to the CD changer later.

Fig 3: CD Changer, Bracket And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take four screws, the bracket and the DVD reader from the kit. Tighten the DVD reader at the bracket.

Applies to cars with a CD changer

Fig 4: CD Changer, DVD Reader, Bracket And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Secure the DVD reader by the bracket for the CD changer using the four screws from the kit
Connect a short DIN cable (1) (purchased separately) to the CD changer
Press the clip (2) into the hole in the left-hand front edge/lower edge of the bracket.

Fig 5: DVD Reader Installed

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the bracket with the DVD reader behind the wheel arch using the four screws (1) from the kit as shown. Tighten the screws. Tighten to 10 Nm (7 lbf. ft).

Applies to cars with a CD changer

Fig 6: CD Changer/DVD Reader Installed

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the bracket with the CD changer/DVD reader behind the wheel arch using the four screws (1) from the kit as shown. Tighten the screws. Tighten to 10 Nm (7 lbf. ft).