Cable routing
- Route the wiring (A in the kit graphic) for the display screen and the radio, and the loose cable for the display screen with the ten pin connectors (B in the kit graphic) for the radio socket between the air duct (1) and the stay (2). Ensure that the straight connector on the loose cable (B) is routed to the hole for the radio
- Route the display screen green 5-pin power supply connector (3) and the cable (B) to the left of the air ducts above the hole for the radio. Continue up through the cut out for the dashboard loudspeaker
- Secure the wiring in the stay (2) using a tie strap (4)
- Route the wiring above and along the air duct (1) to the member (5)
- Clamp the wiring at the existing cable harness (6) using a tie strap.
- Route both cables (A and B in the kit graphic) under the carpet. Continue along the left-hand side of the car to the rear door
- Install protective caps on the lugs (1) for the cable ducts
- Route the wiring further above and along the front cable duct (2). Continue along the right hand side of the rear cable duct (3)
- Connect the ground lead in the rear ground terminal (4) at the left side of the rear seat.
Applies only to cars with a CD changer
- Disconnect the existing ground lead and secure it out of the way.
- Route the wiring (A and B) under the wiring at the cable duct (1). Continue out through the hole in the car body by the front edge of the wheel arch
- Route the wiring along the inside of the cable duct (2) and the insulation panel by the wheel arch in the cargo compartment
- Pull forwards and position the wiring as shown.
Applies to cars without a CD changer
- Install the small bracket (1) (for the DVD reader bracket) onto the rear crossmember under the left tail lamp. Use the screw (2) from the kit.