Installing the GPS antenna

Fig 1: Cleaning GPS Antenna

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the GPS antenna from the kit and clean the underneath using isopropanol P/N 1161721. Wipe dry.

Fig 2: Removing White Backing Film From Tape

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the double-sided adhesive tape from the kit and remove the white backing film from the tape.

Fig 3: Pressing Double-Sided Adhesive Tape On Underneath Of GPS Antenna

Courtesy of VOLVO CARS OF NORTH AMERICA.

Press in the double-sided adhesive tape firmly on the underneath of the GPS antenna.

Fig 4: Cleaning Marked Surface On Parcel Shelf

Courtesy of VOLVO CARS OF NORTH AMERICA.

Clean the marked surface on the parcel shelf using isopropanol P/N 1161721 for mounting the GPS antenna. Wipe dry.

Fig 5: Removing Translucent Backing From Tape On GPS Antenna

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 6: GPS Antenna, Holder And Tie Straps

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the GPS antenna (1) and press it in the rear edge on the parcel shelf in the position as shown.
Route the cable to the GPS antenna along the existing cable for the loudspeaker, inside the holder (2) for the seatbelt.
Clamp at the points (3) with tie straps from the kit.
Route the cable through the hole at the front edge of the wheel housing, out to the cargo compartment.
NOTE: Make sure that the cable does not chafe against sharp edges.