Installing the DVD reader

Fig 1: Cable Harnesses And Ties

Courtesy of VOLVO CARS OF NORTH AMERICA.

Secure the pre-routed cable harness at the cable duct using two tie straps (1)
Secure the blue connector (this will not be used) together with the cable harness that was connected to the fuse holder at the cable harness for the fuse holder. Use a tie strap (2).

Only applies to cars with a CD changer

Secure the cable harness at the cable duct. Use two tie straps (1)
Secure the blue connector, disconnected from the CD changer, together with the cable harness connected to the fuse holder at the cable harness for the fuse holder. Use a tie strap (2).

Fig 2: CD Changer, Bracket And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take four screws, the bracket and the DVD reader from the kit. Tighten the DVD reader at the bracket.

Applies to cars with a CD changer

Fig 3: CD Changer, DVD Reader, Bracket And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Secure the DVD reader by the bracket for the CD changer. Use four screws from the kit.

Fig 4: DVD Reader Installed

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the bracket with the DVD reader behind the wheel arch. Use four screws (1) from the kit as shown. Tighten the screws. Tighten to 10 Nm (7.4 lbf ft) .

Applies to cars with a CD changer

Fig 5: CD Changer/DVD Reader Installed

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the bracket with the CD changer/DVD reader behind the wheel arch. Use the four screws (1) from the kit as shown. Tighten the screws. Tighten to 10 Nm (7 lbf ft) .