Connecting the DVD reader

Fig 1: Connecting The DVD Reader

Courtesy of VOLVO CARS OF NORTH AMERICA.

Connect: 

• the cable (1) for the display screen
• the power supply cable (2) (green connector)
• the cable (3) for the Global Positioning System (GPS) aerial
• the DIN cable (4) for the radio
• Secure the cable harness at the cable duct. Use a tie strap (5) as shown.

Applies to cars equipped with a CD changer 

Fig 2: Connecting The DVD Reader And CD Changer

Courtesy of VOLVO CARS OF NORTH AMERICA.

Connect: 

• the cable (1) for the display screen
• the power supply cable (2) (green connector) for the DVD reader
• the cable (3) for the Global Positioning System (GPS) aerial
• the short DIN cable (4) (purchased separately) between the CD changer and the DVD reader
• the blue connector (5) to the power supply for the CD changer
• the DIN cable (6) previously disconnected from the CD changer
• Secure the cable harnesses using a tie strap (7).

Fig 3: Aerial Amplifier, Cable And Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Does not apply to USA 

• Take the aerial amplifier (1) from the kit. Connect the cable (2) to the connector (3) for the aerial in the rear bumper by the right-hand tail lamp
• Position the aerial amplifier on the panel edge in front of the right-hand tail lamp
• Tighten the aerial amplifier onto the edge of the panel.

Fig 4: DVD Reader, Tie Strap And Lower Socket

Courtesy of VOLVO CARS OF NORTH AMERICA.

Does not apply to USA 

• Take the transparent cable (E in the kit graphic) from the kit
• Connect the green connector (1) to the DVD reader
• Route the cable under the bracket for the DVD reader, continue along the cable harness in the rear crossmember and forwards to the right-hand tail lamp
• Connect the cable to the lower socket (2) on the aerial amplifier
• Secure the cable at the rear crossmember and under the bracket for the DVD reader. Use tie straps (3).