Installing the DVD reader

Fig 1: Cable Harnesses And Ties

Courtesy of VOLVO CARS OF NORTH AMERICA.

Applies to cars without a CD changer

Secure the pre-routed cable harness at the cable duct using two tie straps (1).
Secure the blue connector (this will not be used) together with the cable harness that was connected to the fuse holder at the cable harness for the fuse holder. Use a tie strap (2).

Only applies to cars with a CD changer

Secure the cable harness at the cable duct using two tie straps (1).
Secure the cable harness which was connected to the fuse holder at the cable harness for the fuse holder. Use a tie strap (2).

Applies to cars without a CD changer

Fig 2: CD Changer, Bracket And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Applies to cars with a CD changer

Fig 3: CD Changer, DVD Reader, Bracket And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take four screws, the bracket and the DVD reader from the kit. Tighten the DVD reader at the bracket.

Applies to cars without a CD changer

Fig 4: DVD Reader Installed

Courtesy of VOLVO CARS OF NORTH AMERICA.

Applies to cars with a CD changer

Fig 5: DVD Reader Installed

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the bracket with the DVD reader behind the wheel arch. Use four screws (1) from the kit as shown. Tighten the screws. Tighten to 10 Nm (7 lbf. ft.) .