Installing and connecting the display screen
Applies to cars without center loudspeakers
- Install the bracket (1) on the display (2).
- Secure the bracket. Use the three screws (3) from the kit.
Applies to cars with center loudspeakers
- Install the bracket (1) on the display screen (2). Use the front screw (3).
Applies to cars without center loudspeakers
- Connect the wiring for the DVD reader (1) to the display (2).
- Install the display screen and the bracket in the dashboard. Use the existing screws (3).
- Press the new loudspeaker grille (from the kit) into place on the dashboard.
Applies to cars with center loudspeakers
- Install the centrally mounted loudspeaker in the cut-out in the bracket for the display screen.
- Tighten the center loudspeaker. Use the four screws.
- Press the connector (1) for the center loudspeaker into the bracket on the left-hand under side of the bracket for the display screen.
Applies to cars with center loudspeakers
- Connect the three cables (1) to the display screen and the centrally mounted loudspeaker.
- Press the display screen and bracket into the dashboard. Tighten using the 3x existing screws (2).
- Press the new loudspeaker grille (from the kit) into place on the dashboard.
- Connect the green female connector on the new cable harness to the green male connector disconnected from the radio.
- Connect the other two large connectors to the radio.
- Connect the DIN cable between the radio and the CD changer/DVD reader.
- Connect the remaining connectors which were disconnected from the radio.
- Refit the radio.
- Connect the connectors to the dashboard environment panel. Reinstall the dashboard environment panel.
- Reinstall the panel and gear selector lever boot around the gear selector lever.
- Reposition the carpet at the left front seat.
- Refit the center console's side panel.
- Refit the sill trim panel in the left front and rear door.
- Return the left front seat to an upright position.
- Tighten the screws in the front edge of the seat. Use new screws from the kit. Tighten to 40 Nm (30 lbf. ft.) . Reinstall the covers over the screws.
- Reinstall the parcel shelf.
- Connect the connectors for the cargo compartment lamps on the rear crossmember panel. Reinstall the crossmember panel.
- Reinstall the left front side panel in the cargo compartment.
- Reinstall the right-hand folding panel and a new left-hand folding panel from the kit.
- Reinstall the side cushion.
- Fold the backrest back into place.
- Reinstall the seat cushion.