Cable routing

Fig 1: Identifying Air Duct, Connectors, Wiring, And Stay

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Route the wiring for the display screen and the radio (A in the kit graphic), and the DIN wiring for the radio (B in the kit graphic) between the air duct (1) and the stay (2).
• Route the cable ends, with the blue 5-pin connector (3) for the power supply and the grey angled connector (4) for the display screen to the left of the air ducts above the cut-out for the radio to the cut-out for the dashboard loudspeaker.
• Clamp the wiring to the stay (2). Use the tie strap (5) from the kit.
• Route the wiring above and along the air duct (1) to the member (6).
• Secure the wiring at the existing cable harness (7). Use the tie strap from the kit.

Fig 2: Identifying Lugs, Front And Rear Cable Ducts

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Route both cables (A and B in the kit graphic) under the carpet. Continue along the left-hand side of the car to the rear door.
• Fit protective caps on the lugs (1) of the cable ducts.
• Route the wiring further above and along the front cable duct (2). Continue along the right-hand side of the rear cable duct (3).

Fig 3: Identifying Cable Ducts

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Route the wiring (A and B) under the wiring at the cable duct (1). Continue out through the hole in the car body by the front edge of the wheel arch.
• Route the wiring along the inside of the cable duct (2) and the insulation panel by the wheel arch in the cargo compartment.
• Pull the wiring forwards and position as shown.

Fig 4: CD-ROM Reader Bracket And Screw

Courtesy of VOLVO CARS OF NORTH AMERICA.

Applies to cars without a CD changer 

• Install the small bracket (1) (for the DVD reader bracket) onto the rear crossmember under the left tail lamp. Use the screw (2) from the kit.