Adjustment Of Light Propagation: Adjustment

WARNING: Always adjust the light propagation according to the local law.

Fig 1: Adjusting Beam Vertically And Horizontally (1 Of 2)

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition and low beam on.
• Check the amperage so there are enough current for correct light propagation.
• Undo the cap, over the adjusting screw for the light propagation laterally (X), by drawing upwards.
  CAUTION: Always adjust the light propagation with low beam on.

Fig 2: Adjusting Beam Vertically And Horizontally (2 Of 2)

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Adjust the light propagation in vertical height (Y) by using a socket screw as shown.
• Adjust the light propagation laterally (X) by using a socket screw.
• HINT: Use socket screw Ø 6 mm. 

WARNING: Always adjust the light propagation according to the local law.