Installing the screen holder and center loudspeaker

Fig 1: Cutting Away Attached Washer

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Threading Cable Through Hole In Screen Holder

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the cable with yellow and large black connector to the screen from the kit. Thread the cable through the hole in the screen's holder.

Fig 3: Fitting Large Connector To Screen Holder

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Fitting Washer For Mounting Screen Holder To Bracket On Underside Of Holder

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the washer for mounting the screen's holder to the bracket and fit it on the underside of the holder.

Fig 5: Tightening Connector To Holder With Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 6: Aligning Screen Holder In Console And Attaching With Screw

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the console which secures the complete unit in the dashboard from the kit. Align the screen's holder in the console and attach it with a screw from the kit. Do not tighten hard yet.

Fig 7: Installing Loudspeaker In Console With Screen Holder Using Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the loudspeaker from the kit. Install the loudspeaker in the console together with the screen's holder with screws from the kit. The loudspeaker must be aligned with the cable connectors to the right in the car.
Tighten all screws to the loudspeaker and holder.

Fig 8: Clamping Both Cable Harnesses From Kit At Existing Cable Harness

Courtesy of VOLVO CARS OF NORTH AMERICA.

Align the screen with console and cable at the hole for the center loudspeaker.
Guide the free connector down through the hole to the center loudspeaker, along the left-hand inside of the center console, along the air ducts under the floor carpet and out at the sill to the left-hand front door.
Take the remaining long cable harness from the kit and route it the same way as above, but start by guiding it up by the sill under the carpet at the left-hand front door, with the two grey connectors and relay first.
Clamp both cable harnesses at the existing cable harness, at point (1) and at the strut (2) in the center console. Use tie straps from the kit.

Fig 9: Identifying Loudspeaker Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Connect the routed cable harness with the two grey connectors and relay as follows:
1. The grey connector (1) in the routed cable harness to the corresponding connector (2) in the cable to the center loudspeaker.
2. The grey connector (3) in the routed cable harness to the connector (4) in the cable on the center loudspeaker.
Install the complete unit in the hole in the dashboard with the existing screws.
NOTE: Make sure that the relay and cables are not trapped.