Installing the TMC receiver, only applies to cars in Europe

Fig 1: Cleaning Underside Of TMC Receiver

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the TMC receiver from the kit and clean the marked surface on the underside using isopropanol P/N 1161721. Wipe dry.

Fig 2: Cutting Velcro Fasteners Into Four Pieces Of Equal Length

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take two of the long Velcro fasteners from the kit and cut them into four pieces of equal length.

Fig 3: Removing Protective Tape

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Pressing In Velcro Fasteners

Courtesy of VOLVO CARS OF NORTH AMERICA.

Firmly press in the Velcro fasteners on the underside of the TMC receiver, approximately in the positions shown.

Fig 5: Pressing In Velcro Fasteners Centered Against Velcro Fasteners On TMC Receiver

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the two remaining Velcro fasteners.
NOTE: Do not remove the protective tape.

Press in the Velcro fasteners centered against the Velcro fasteners on the TMC receiver.

Fig 6: Connecting White Connector In Routed Cable Harness To TMC Receiver

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 7: Removing Protective Tape From Velcro Fasteners

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 8: TMC Receiver On Top Of CD Drive

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the TMC receiver on the top of the CD drive as shown and press it in. Press in firmly so that the tape adheres.

Fig 9: Identifying Yellow Connector And Green Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Attach the yellow (1) connector from the screen to the green connector (2) on the routed cable harness.

Fig 10: Aerial Amplifier, Cable And Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the solid core wire from the kit and lay it along the rear crossmember.
NOTE: The cable end with the angled connector must be on the left-hand side.
Route the connector to the TMC unit. The cable must be routed on the underside of the fuse holder along the existing cable harnesses.
Route the other end of the cable in front of the right-hand tail lamp to the antenna amplifier.
Detach the cable and remove the existing amplifier on the right-hand side of the right rear side member, under the right-hand rear lamp.
Take the antenna amplifier (1) from the kit. Connect the cable (2) to the connector (3) for the antenna in the rear bumper by the right-hand tail lamp.
Position the antenna amplifier on the edge of the panel in front of the right tail lamp as shown.
Tighten the antenna amplifier.

Fig 11: Connecting Routed Cable To Lower Socket On Antenna Amplifier

Courtesy of VOLVO CARS OF NORTH AMERICA.

Applies to cars from and including model year 2005-

Clamp the cable at the existing cable harness under the tailgate sill panel with four tie straps (2) from the kit.

Applies to cars up to and including -2004

The cable to the antenna amplifier is clamped up together with the adapter wiring to the towbar wiring.