Replacing driver door module (DDM)

Fig 1: Identifying Ignition OFF

GLL101045

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off.
The driver door module (DDM) has registered an internal fault.

NOTE: A new control module is delivered without software. The control module must be programmed when it has been replaced.

Other information:
- For further information about programming and replacing the control module, see Driver's door module/passenger door module (DDM/PDM), replacing .
After replacing the control module the window position must be initialized.

Ignition on.

Move the window to its upper limit position using manual control.

Initialize the window.

From model year 2003 inclusive, the window will lower approximately 10 centimeters and then close again during initialization.

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS OF NORTH AMERICA.