Installing the dial gauge

Fig 1: Brake Caliper Bracket

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the bracket, included in the test equipment, in the upper mounting hole for the brake caliper first.

Press the bracket against the constant velocity joint housing.

Then install the lower mounting screw in the hole. At the same time, secure the bracket using the lower screw. Tighten the nuts.

Use the M12 screws and nuts included in kit 9995507 .

Fig 2: Dial Gauge In Bracket

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the dial gauge in the bracket as shown in the illustration.