Brakes - Adjustment, Removal & Installation
- Brakes
- Brake calipers front, replacing
- Brake calipers rear, replacing
- Brake calipers, front, reconditioning
- Brake Control Module (BCM), replacing
- Brake disc front, replacing
- Removal
- Removing the brake caliper holders and brake disc
- Cleaning and checking
- Installation
- Front wheel hub, measuring lateral runout
- Front wheel hub, replacing
- Notes
- Preparation
- Removing brake calipers
- Removing the screw for the drive shaft
- Removing the brake disc
- Disconnecting the steering arm
- Disconnecting the anti-roll bar link
- Disconnecting the cable harness for the ABS sensor
- Removing the control arm from the ball joint
- Removing the hub
- Tightening torque
- Installing the hub
- Installing the control arm on the ball joint
- Installing the cable harness for the ABS sensor
- Installing the anti-roll bar link
- Installing the steering arm
- Installing the brake disc
- Installing the drive shaft screw
- Installing brake calipers
- Finishing
- Brake disc rear, replacing
- Brake fluid reservoir, replacing
- Brake pads front, replacing
- Brake pads rear, replacing
- Brake pipe master cylinder / ABS unit, replacing
- Control module (ABS), replacing
- Hydraulic unit, ABS, replacing
- Master cylinder, replacing
- Parking brake self-adjustment, resetting (version 1)
- Parking brake self-adjustment, resetting (version 2)
- Pedal sensor power brake booster, replacing
- Power brake booster, replacing
- Power brake booster (DSTC), replacing (version 1)
- Preparation
- Removal
- Preparations for removing the power brake booster
- Preparations for removing the ABS unit
- Remove the ABS unit and bracket from the side member
- Preparations for removing the master cylinder
- Remove the master cylinder
- Transfer the components to the new power brake booster
- Remove the nuts for the power brake booster at the pedal box
- Installation
- Install the power brake booster
- Install the push rod for the power brake booster and the retaining clip on the brake pedal
- Install the master cylinder
- Install the connectors and vacuum hose
- Install the ABS unit and the bracket
- Install the brake pipes in the master cylinder and in the hydraulic modulator
- Install the cross member
- Checking the power brake booster
- Power brake booster (DSTC), replacing (version 2)
- Notes
- Removal
- Preparations for removing the power brake booster
- Remove the master cylinder
- Remove the nuts for the power brake booster at the pedal box
- Remove the splash guard under the engine
- Remove the mounting screw for the cable conduit
- Remove the three cross members under the car
- Remove the locking screw and lock from the steering gear
- Cars with passenger compartment heaters
- Preparations for removing sub-frame screws
- Lower the sub-frame
- Lower the car. Remove the power brake booster
- Installation
- Transfer the terminals and seals to the new power brake booster
- Install the power brake booster with the terminals for the check valve
- Tighten the power brake booster
- Install the master cylinder
- Install the connections on the master cylinder
- Lift the sub-frame
- Install the steering components
- Secure the sub-frame
- Install the cross members
- Pressure sensor, master cylinder, replacing