Removing The Sub-Frame

Fig 1: Identifying Brake Hose Bracket

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

Ensure that no cables/hoses are trapped when lowering the sub-frame.

Use a post-lift with lifting table. Position the lifting table against the sub-frame.

NOTE:

Make sure that the lifting table is centered under the subframe for optimal weight distribution. Check that the lifting table is correctly applied against the subframe.

Remove:

the screw, 1 pc. (1), on both sides
the screws, 2 pcs. (2), on both sides.

Lower the sub-frame approximately 5 cm.