Checking The Wiring
- Ignition off.
Check the wiring between the keyless vehicle module (KVM) and the connector for the quick lock motor. Check for an open-circuit. Check for a short-circuit to ground. Check for short-circuit to supply voltage.
Other information
- see CONNECTING THE BREAKOUT BOX (2005, 2006, 2007)
- see DRIVER DOOR MODULE (DDM)
- see SIGNAL SPECIFICATION (2005, 2006, 2007)
- see DRIVER DOOR MODULE (DDM)
- To access the front door control module, see: DRIVER DOOR MODULE (DDM)
- see CHECKING WIRING AND TERMINALS
Was a fault detected?
- YES
Refer to VERIFY
- NO
Refer to REPLACING THE COMPONENT