Installing The Control Module

• Take the cable harness and control module from the kit. Connect the cable harness to the control module (1).
• Lock the catch (2).

• Get a thick foam tape from the kit and fasten it on the front of the control module. Fold up the foam tape around the corners and edges of the control module.

• Get three small pieces of foam tape from the kit and fasten these on the back of the control module.

• Detach the front sill molding by first pulling it backwards at the front edge and then straight up so that the clips release.

• Unscrew the clips holding the floor carpet.
• Fold aside the floor mat to access the bulkhead panel inside.
  NOTE: Take care not to create folds in the carpet.

• Place the control module with the thick foam tape forward, against the bulkhead.

• Fold aside the cable harnesses (1) so that they do not end up between the control module and floor mat.
• Route the control module's cable harness under the cable harnesses (2) and on toward the tunnel console.
• Fold back the carpet.

• Connect the connectors for the Bluetooth system as shown:

  Applies to cars with internal amplifier 

  1. Connect cable harness A to the cable from the control module.
• Take one of the cut pieces of foam tape and tape around the connectors.

• Place the connectors and the excess wiring inside the center console.
• Fold back the carpet.

• Take two large tie straps from the kit and secure the cable from the microphone on top of the collision pipe.

Applies to cars with external amplifier 

• Also secure the cable harness B, that is to be later routed back to the external amplifier.