Apply To The S40

• Turn the ignition switch to position 0.
• Remove the cargo compartment carpet.

Applies to cars with a high cargo compartment floor 

• Remove the upper floor supports on the right and left-hand sides. The left-hand floor support shall not be used again.

Removing the sill trim panel from the boot lid: 

• Unscrew the two external clips at the front edge/bottom edge of the sill trim panel on the boot lid.
• Pry up one of the corners of the sill trim panel using a weatherstrip tool so that the two clips at that end release.
• Pull up the sill trim panel at the other end so that the remaining two clips release. Remove the sill trim panel.
• Remove the rubber strip from the boot lid opening where it covers the side panels on the left and right-hand sides.

• Fold forward the seat cushions and backrests on both sides of the rear seat.

Removing the side cushion: 

• Grasp the upper edge of the left-hand side cushion. Pull the side cushion forward so that the clip on the rear side releases.
• Slide the side cushion upwards.
• Remove the right-hand side cushion in the same way.

Removing the side panels: 

• Remove the five clips (1) holding the left-hand side panel in the bodywork.
• Unhook the front edge of the parcel shelf panel at the mounting (2). Pull the side panel away from the parcel shelf panel and the panel on the C-post.
• Unhook the side panel from the mounting (3) on the underneath of the parcel shelf.
• Unhook the side panel from the load securing eyelet (4). Remove the side panel.
• Remove the right-hand side panel in the same way.

• Remove the lower floor supports on the right and left-hand sides by unscrewing the three clips in the bottom of the compartments, and then lifting them out. The left-hand floor support shall not be used again.

• Remove the screw in the bracket for the rear seat backrest.

• Take the subwoofer from the kit and turn it so that the front of the speaker faces up.
• Take three screws from the same kit and install the bracket for the S40 on the subwoofer as shown. (Foam padding and V50 bracket not used.)

• Take two screws from the kit. Install the front bracket on the subwoofer.

• Position the subwoofer in the left-hand side of the cargo compartment.
• Take the M8x24 screw (1) and washer from the kit. Install the screw and washer in the left-hand bracket.
• Take the screw (2) from the bracket for the backrests. Install the screw in the right-hand bracket for the subwoofer.
• Tighten the M10 screw. Tighten to 50 Nm (37 lbf. ft.)  .
• Tighten the M8 screw. Tighten to 24 Nm (18 lbf. ft.)  .