Mobile Computing Services (2004-11): Removal: Overview
Remove the panel.
Remove the clip.
Remove the panel.
Remove the screw.
Remove the screws.
Remove the panel.
Disconnect the connectors.
Remove the cable tie(s).
Detach the panel.
Unhook the clip(s).
Pull the wiring through.
Use: Melting adhesive, 1161656
Fold the insulation to one side.
Pull the wiring through.
see 9512932
Install the panel.
Connect the connectors.
Tear off the excess foam tape.
Clamp the cables and connectors to the existing cables to prevent noise.
Reinstall the removed parts in reverse order.