Mobility Connection Package: Notes

NOTE:

Navigation system portable:

The disc marked A in the kit illustration is used on cars with loudspeaker grilles.

Bluetooth handsfree:

There may be components in the accessories kit that are not used for this installation.

Place the manual for this accessory in a suitable place in the vehicle.

USB/iPod Music Player:

This accessory requires software unique to the car.

Fig 1: Identifying Wrench, Screws And Nuts

GLL165528

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

Take care when handling the components, they are fragile and are easily damaged.

Take the three screws M5x25 part no. 986957 and nuts from the kit.
To prevent excessive resistance when the nut for the holder is tightened, hold the screw and screw the nut on and off the threaded part of the screw. Carry this out on all screws and nuts.

Fig 2: Identifying Removal Screws Holding Connector In Holder

GLL164151

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take special tool 9814104 (Torx driver, Torx 6), and unscrew the two screws holding the connector in the holder.
Carefully push the connector to one side with the cable to expose the bottom of the holder.

Fig 3: Identifying Spacers

GLL164152

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the kit with the four spacers from the installation kit.
Carefully pry off the spacer using P/N 31212784 . The part number (1) is on the bottom of the spacer.

Fig 4: Identifying Screws Inserted In Spacer

GLL164154

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the three screws and insert them in the spacer fully.

Fig 5: Applying Pieces Of Butyl Tape To Screws

GLL164155

Courtesy of VOLVO CARS OF NORTH AMERICA.

Apply pieces of butyl tape to the screws so that the screw heads do not protrude outside the spacer when installing it.

Illustration A

Fig 6: Identifying Spacer In Bottom Of Holder

GLL164153

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the spacer in the bottom of the holder.

Illustration B

Fig 7: Identifying Spacer Secured In Position

GLL164156

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ensure that the holder's two screw turrets align between the small pins in the oblong holes in the spacer. A click should be heard when the spacer is securely in position.

Fig 8: Aligning Guide Hole With Pin At Bottom Of Holder And Holes In Circuit Board Are Over Screw Turret

GLL164157

Courtesy of VOLVO CARS OF NORTH AMERICA.

Place the connector in the bottom of the hole. The guide hole (1) in the connector's circuit board must align in the corresponding pin at the bottom of the holder and the holes (2) in the circuit board must be over the holder's screw turret.

Fig 9: Identifying Connector Tightened To Holder With Torx Screws

GLL164158

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the small Torx screws and carefully tighten the connector to the holder. Ensure that the connector's circuit board is properly against the screw turret and that there is no play.
Remove the butyl tape from the screws.

Fig 10: Identifying Ignition Switch Turned To Position 0

GLL157537

Courtesy of VOLVO CARS OF NORTH AMERICA.

Turn the ignition key to position 0.

NOTE:

Wait at least three minutes before unplugging the connectors or removing other electrical equipment.