Applies To All Models
- Remove the two screws along the front edge of the tunnel console.
Illustrations A and B
- Carefully pull up the lock catch with special tool 9995919 . At the same time, slide the whole tunnel console backward so that the two rear screws in the center console's panel can be accessed.
- Remove the two screws.
- Remove the two screws holding the center console to the dashboard.
- Remove the connector on the reverse of the dashboard environment panel.
- Remove the center console's panel from the dashboard and tunnel console.
- Remove the two clips securing the cables to the media player by first pressing them to the sides and then pulling them away downwards.
NOTE:
Make sure that the optic cables are not bent or stretched. They may not be bent with a radius less than 25 mm (1").
- Remove the two screws from the bottom of the media player.
- Pull out the media player and unplug the connectors on the back. Lay it aside, new is included in the kit.
Illustrations A and B
- Take the new media player from the kit, and the two existing screws.
NOTE:
Make sure that the fibre optic cable is routed so that it is bent to a radius of no less than 25 mm (1").
- Plug in the connectors to the media player.
- Install the media player in the dashboard.
- Guide in the lug (1) at the rear of the media player with one hand. The lug must be in the matching hole on the back of the heater.
- Tighten the media player using the two screws.
- Refit the center console.
- Connect the climate panel connector.
- Turn the ignition key to position II.
- Reconnect the battery negative lead.
- Program the software in accordance with the service information in VIDA (Volvo scan tool).