Fit the wheel
WARNING: This page is about a different variant/trim than selected.
Check that the contact surfaces of the brake disc and brake pads are clean.
Grease the central hub guide pin in front of the brake pad with corrosion inhibitor, part number 1161038-3.
Position the wheel and loosely tighten the bolts.
Then tighten diagonally opposite bolts alternately to 110 Nm .
When tightening with a percussion wrench, torque socket 9512661 must be used.
Retighten by hand.
CAUTION:
Tighten in crosswise sequence to the correct tightening torque to avoid stresses in the brake disc.
Fit the hub cap.