Faulty Signal (2008, 2009, 2010, 2011): Fault-Tracing: Verification
Check that the fault has been rectified by performing a new test for the DTC.
- Disconnect any battery chargers.
- Close doors, hood, and tailgate.
- Activate the alarm with the remote key.NOTE:
If the vehicle is equipped with a Keyless vehicle module (KVM), the remote key must be positioned approx. 10 meters away from the vehicle in order to activate the alarm.
- Read off the DTCs in VIDA and check that CEM-CFF0 has changed status to intermittent.
Is the status of the diagnostic trouble code (DTC) intermittent?
- YES
OKAY: Troubleshooting has been completed.
- NO
Refer to INFORMATION