Checking Component And Wiring

Check the voltage on the left-hand headlamp connector terminal #1 to the output on the central electronic module (CEM). The voltage must be approximately 12 V when the left-hand turn signal lamp is activated.

Check the control signal cable. Check for a short-circuit to ground.

Take readings between:

• Central electronic module (CEM) terminal #E38 (#38) and left-hand headlamp connector terminal #1.

Check the voltage on the rear right-hand lamp housing connector terminal #3 to the output on the central electronic module (CEM). The voltage must be approximately 12 V when the left-hand turn signal lamp is activated.

Check the control signal cable. Check for a short-circuit to ground.

Take readings between:

• Central electronic module (CEM) terminal #C9 (#9) and rear left-hand lamp housing connector terminal #3.

Remedy as necessary.

Other information 

• see CONNECTING THE BREAKOUT BOX (2008, 2009, 2010, 2011)
• see SIGNAL DESCRIPTION CENTRAL ELECTRONIC MODULE (CEM) (2008, 2009, 2010, 2011)
• see CONTROL MODULE RELAY BOX PASSENGER COMPARTMENT
• see HEADLAMP BULB (2008, 2009, 2010, 2011)
• see CHECKING WIRING AND TERMINALS

• Continue 

  Refer to VERIFICATION