Installing The Control Panel

• Clean the area on the centre console as shown, which corresponds to the size of the double-sided adhesive tape. Use a solution of 25% isopropanol and 75% water, as well as a lint free cloth.

  Dry with care, do not rub.

• Allow to dry.

A 

• Place the control panel cable in the groove as shown.

B 

• Remove the protective film from the tape and secure the control panel edge to edge against the climate panel and according to the dimensions shown.

• Press the cable securely into the compartment that is in the joint between the front and rear side of the center console. Stop level with the lower edge of the display opening.

• Route the cable from the control panel on the right-hand side of the centre console.

• Reinstall the tunnel console, but do not slide it forward so far that it covers the rear screw holes for the centre console's panel.
• Plug in the connectors at the leading edge.
  NOTE: Protect the hand brake and gear shift when fitting the tunnel console.

• Install the centre console, connect the green connector and fit the screws, two at the top and two on the rear edge.

Applies to cars with manual gearbox 

• Install the gear selector boot in the center console starting at the rear edge.

• slide the tunnel console forward so that the locking lug secures it. At the same time, guide in the floor carpet on the left-hand side.

Reinstall: 

• the two screws at the front edge of the tunnel console.
• the panel at the parking brake.

• Reinstall the screws

• File a slot at the rear of the storage compartment's bottom cover for the USB/iPod cable in the position as shown.

• Place the USB/iPod cable in the bottom cover slot and press it into place.

Reinstall: 

• the ignition control module (ICM) with the connectors, screws and frame.
• front storage compartment inside of the center console.