Installing The Control Panel
- Clean the area on the center console as shown, which corresponds to the size of the double-sided adhesive tape. Use a solution of 25% isopropanol and 75% water, as well as a lint free cloth.
Dry with care, do not rub.
- Allow to dry.
NOTE:
In cases where the area is heavily soiled or treated with cockpit shine. First clean using a washing up detergent (FAIRY or similar).
A
- Place the control panel cable in the groove as shown.
B
- Remove the protective film from the tape and secure the control panel edge to edge against the climate panel and according to the dimension shown.
- Press the cable securely into the compartment that is in the joint between the front and rear side of the center console. Stop level with the lower edge of the display opening.
- Reinstall the center console, connect the green connector and install the screws.
Applies to cars with manual gearbox
- Install the gear selector boot in the center console starting at the rear edge.
- Pull the 2 cables down on the right-hand side of the center console.