Installing The Control Module

Fig 1: Identifying Control Module Cable Harness

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the cable harness and control module from the kit. Connect the cable harness to the control module (1).
Lock the catch (2).

Fig 2: Identifying Thick Foam Tape

Courtesy of VOLVO CARS OF NORTH AMERICA.

Get a thick foam tape from the kit and fasten it on the front of the control module. Fold up the foam tape around the corners and edges of the control module.

Fig 3: Identifying Small Foam Tape

Courtesy of VOLVO CARS OF NORTH AMERICA.

Get three small pieces of foam tape from the kit and fasten these on the back of the control module.

Fig 4: Identifying Front Sill Molding

Courtesy of VOLVO CARS OF NORTH AMERICA.

Detach the front sill molding by first pulling it backwards at the front edge and then straight up so that the clips release.

Fig 5: Identifying Floor Mat

Courtesy of VOLVO CARS OF NORTH AMERICA.

Unscrew the clips holding the floor carpet.
Fold aside the floor mat to access the bulkhead panel inside.
NOTE: Take care not to create folds in the carpet.

Fig 6: View Of Control Module Positioning

Courtesy of VOLVO CARS OF NORTH AMERICA.

Place the control module with the thick foam tape forward, against the bulkhead.

Fig 7: Identifying Control Module And Floor Mat

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fold aside the cable harnesses (1) so that they do not end up between the control module and floor mat.
Route the control module's cable harness under the cable harnesses (2) and on toward the tunnel console.