Drive shaft and stub axle, installing

Fig 1: Identifying Drive Shaft And Stub Axle Installation

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the mobile jack 9985972 as a support under the control arm.

• Align the drive shaft in the hub
• Lubricate the shaft splines using grease, P/N 1161246-2.

Install: 

• the new  screws for the stub axle. Use new  lock nuts. Tighten to 90 Nm 
• counterhold 9995683
• the drive shaft nut. Lubricate the nut before installing. Tighten. See Centre nut, drive shaft and tightening torque . Remove the counterhold.