Installing the Rear Wheel

Fig 1: Identifying Wheel Installation

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that the brake disc and wheel rim mating surfaces are clean.

Lubricate the hub center guide using rustproofing agent P/N 1161038-3.

Install the wheel. Tighten the nuts loosely.

Then tighten crosswise to 110 Nm .

When tightening with an impact wrench, torque socket 9512834 must be used.

CAUTION: The correct tightening torques and crosswise tightening for the nuts are essential to avoid stresses in the brake disc.

Install the hub cap.