Install the headlamp wiper arm

Fig 1: Installing Headlamp Wiper Arm

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Install the washer hose.
• Install the new wiper arm.
• Loosely install the nut and washer.
• Adjust the position of the wiper arm as shown.

HINT: Adjust the headlamp wiper on the left hand side of the car so that the wiper blade is not under the stop when the nut is tightened. Then lift the wiper blade above the stop: the wiper blade should lie against the stop under tension (position A.). On the right hand side of the car the wiper blade should lie above the stop when the nut is tightened (position B.). 

• Tighten the nut: Tightening torque 4 Nm.
• Test the function of the headlamp washer/wiper. Check that wiper arms park horizontally.