Installing the Wheels

Fig 1: Identifying Wheel Installation

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that the mating surface on the brake discs and the wheel rims are clean.

Lubricate the hub center guide for the rim using anti-corrosion agent, Volvo P/N 1161038-3.

Install the wheel. Tighten the nuts lightly. Then tighten the screws crosswise. Tighten to 110 Nm. When tightening using an impact wrench, torque socket 9512834 must be used.

NOTE: Crosswise tightening and the correct tightening torques are important to avoid stresses in the brake disc.