Installing the rear bumper

Fig 1: Rear Bumper Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Place tape underneath the tail lamps and on the tow hitch to prevent paintwork damage.

Align the bumper with the car body.

Install:

Tighten the screw (C). Tighten to 50 Nm . Tighten the nuts (A, B). Tighten to 5 Nm on the left and right-hand sides.

NOTE:

Install the screw and washer (D) if the vehicle is equipped with a tow hitch. Tighten to 55 Nm .

Fig 2: Mudguard And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Connect the connector for the parking lamps on the right and left-hand sides.

Install the screw (A) on the left and right-hand sides.

Install the mudguard on the left and right-hand sides using the three screws.

Fig 3: Installing Cargo Compartment Side Panel And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Installing Cargo Compartment Side Panels

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

(For V40 equipped with extra loudspeakers see Removing / installing additional loudspeakers .)

Clean the bumper.