Checking the wiring

Check the cable between VGLA control module terminal #A16 (A16) and the control switch connector terminal #1. Check for an open-circuit. See Open-circuit, permanent faults .

Check the cable between the control switch connector terminal #2 and ground. Check for an open-circuit. See Open-circuit, permanent faults .

Fig 1: Vehicle Tilt Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Verification 

Check the cable between VGLA control module terminal #A18 (A18) and the control switch connector terminal #3. Check for an open-circuit. See Open-circuit, permanent faults .

Check the cable between the control switch connector terminal #2 and ground. Check for an open-circuit. See Open-circuit, permanent faults .

Fig 1: Vehicle Tilt Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Verification