Removing/Installing Rear Bumper

Prerequisites

To remove the rear bumper fold back or remove the rear panels:
S40 Removing the rear panel

Removing rear bumper

Fig 1: Splash Guard Mounting

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Cargo Compartment Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Installing rear bumper

Fig 3: Tape Protecting Paintwork

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position tape under tail lamps (and if the car is equipped with a tow bar also apply tape to the bumper) to avoid damage to paintwork when installing the bumper
Install bumper.

Fig 4: Cargo Compartment Screws With Torque Specifications

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install screw/nut A, nut B and screw C (tighten to 50 Nm) on both the left and the right hand sides
Install clip D on underside of bumper.

Fig 5: Side Marker Lamp Connector And Splash Guard Mounting

Courtesy of VOLVO CARS OF NORTH AMERICA.

Work remaining