Connecting The Breakout Box
- Ignition off
- Expose the integrated relay/fusebox in the cargo compartment
- Remove fuses 11D/1 and 11D/2 from the integrated relay/fusebox in the cargo compartment
- Release the locking hooks on the top of the integrated relay/fusebox in the cargo compartment
- Fold the integrated relay/fusebox in the cargo compartment downwards/inwards. The integrated relay/fusebox in the cargo compartment can now be removed
- Slacken off the screw holding the rear electronic module (REM) connector so that it can hang free
- Disconnect the rear electronic module (REM) connector. The connector may be stiff.
Connect the adapter between the rear electronic module (REM) and its connector. Connect the breakout box to the adapter. Breakout box wiring see 9511503 .
Disconnect the breakout box in reverse order.
NOTE:
Before the rear electronic control module can be checked and measurements taken, the removed fuses must first be installed.
Other information
- For the location of the components, see RELAY/FUSE BOX CARGO COMPARTMENT/REAR ELECTRONIC MODULE (REM), REPLACING
- For further information about signals and other values, see SIGNAL SPECIFICATION .