LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2003 >> XC70 >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Drive Shaft Seal (Right), Turbocharger - Removal & Installation) >> Engine >> Replacing The Wiring Harness / Oil Temperature Sensor >> Removal >> Remove The Gearbox Cable From The Lever On The Gearbox

Remove The Gearbox Cable From The Lever On The Gearbox

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2007 Volvo V70, 2006 Volvo V70, 2005 Volvo V70, 2004 Volvo V70, and 2003 Volvo V70. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Small Connector In Bracket, Connectors On Transmission And Transmission Wiring To Connectors
GLL109383Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove: 

Remove: 

Separate the connectors.

Remove the small connector from the bracket.

Applies only when replacing the control system 

Set the gearbox lever to the neutral position. Move the lever as far forward as possible to position P and then back two steps to neutral.