LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2003 >> XC70 >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Drive Shaft Seal (Right), Turbocharger - Removal & Installation) >> Engine >> Replacing The Wiring Harness / Oil Temperature Sensor >> Removal >> Lowering The Sub-Frame

Lowering The Sub-Frame

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2007 Volvo V70, 2006 Volvo V70, 2005 Volvo V70, 2004 Volvo V70, and 2003 Volvo V70. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Front And Rear Bolts For Sub-Frame
GLL109349Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the mobile jack lightly applied under the left side  of the sub-frame. Remove the front and rear screws from the sub-frame.

Carefully lower the frame a little. Check that the screws for the steering gear release from the frame and the control arm releases from the ball joint. Lower the sub-frame completely and let it hang free.