Installing bumper guard bolts

Fig 1: Identifying Bumper Guard Bolts

GLL119116

Courtesy of VOLVO CARS OF NORTH AMERICA.

Align the studs for the bumper guard in the drilled holes
Install two nuts from the kit on the studs.

NOTE:

Both layers of the bumper cover may need to be clamped together using a clamp or similar so that the nuts can be installed on the studs.

Align the bumper guard so that it is straight
Tighten the nut. Tighten to 3.5 Nm (2.6 lbf. ft)
Remove the clamp (if used)
Reinstall all the air baffles.