Drive Shaft Seal (Right), Turbocharger - Removal & Installation
- Engine
- Drive Shaft Seal, Right, Replacing
- Replacing The Turbocharger (TC)
- Replacing The Wiring Harness / Oil Temperature Sensor
- Notes
- Removal
- Preparations
- Remove The Gearbox Cable From The Lever On The Gearbox
- Disassembling The Large Connector
- Removing The Lever On The Gear Shift Linkage Rod
- Installing The Lifting Beam And Lifting Hook
- Lifting The Car
- Removing The Screw For The Right Drive Shaft
- Removing The Screws For The Cable Conduit And Ground Lead Bracket On The Sub-Frame
- Removing The Ball Joint Nuts (Both Sides)
- Removing The Bracket For The Cable For The Heated Oxygen Sensor (HO2S)
- Removing The Collision Protection System Over The Steering Gear
- Removing The Steering Gear From The Sub-Frame
- Removing The Screws From The Sub-Frame Support Brackets (Both Sides)
- Lowering The Sub-Frame
- Draining The Gearbox Fluid
- Removing The Control System Cover
- Removing The Cable Harness
- Installation
- Connecting the cable harness
- Sealing the cover
- Installing the control system cover
- Installing the sub-frame
- Installing components in the steering gear and sub-frame
- Installing the nuts securing the ball joint to the control arm and the anti-roll bar to the link rods
- Installing the collision protection system over the steering gear
- Installing the bracket for the heated oxygen sensor (HO2S)
- Installing the screw for the drive shaft
- Installing components on the sub-frame
- Installing the splash guard under engine
- Removing Lifting Beams And The Lifting Hook
- Assembling The Connectors
- Safety Information Cooling System