LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2003 >> V70 Base, 2.4 64 >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control - Specifications, Removal & Installation >> Engine Timing >> Replacing the camshaft seals / variable valve timing (VVT) unit (B5234T3; B5244T3; 2001) >> Removing/Installing the rear camshaft seal >> Removing the rear camshaft seal

Removing the rear camshaft seal

Fig 1: Pulling Out The Old Seal. Use Extractor 999 5919
GLL102728Courtesy of VOLVO CARS OF NORTH AMERICA.

Pull out the seal. Use puller 9995919 . To clean the shaft journal and mating surface, use emery cloth P/N 951 1024.

NOTE:

When cleaning work around the shaft journal, not in and out. It is essential that any residue from the emery cloth and any other contaminants are completely removed before the new sealing ring is installed.

Lubricate the surface of the seal that the camshaft rotates against. Install the camshaft seal. Use drift 9995450 .

NOTE:

The seal is normally positioned at the same level as the internally bevelled edge. If the shaft journal is showing signs of wear, the seal can be pressed in a further 2 mm  : Turn the drift socket.

scientia non olet · About LEMON Manuals