Oil Temperature Sensor Wiring - Removal & Installation
- Gauges
- Wiring harness / oil temperature sensor, replacing (AW50/51 AWD; AW55-50/51SN; 2003-2007)
- Wiring harness / oil temperature sensor / solenoids, replacing (AW50/51 AWD; AW55-50/51SN; 2001-2007)
- Notes
- Removal
- Preparations
- Remove the transmission cable from the lever on the transmission
- Disassembling the large connector
- Removing the lever on the gear shift linkage rod
- Installing the lifting beam and lifting hook
- Lifting the car
- Removing the screw for the right drive shaft
- Removing the screws for the cable conduit and ground lead bracket on the sub-frame
- Removing the ball joint nuts (both sides)
- Removing the bracket for the cable for the heated oxygen sensor (HO2S)
- Removing the collision protection system over the steering gear (right-hand drive cars only)
- Removing the steering gear from the sub-frame
- Removing the screws from the sub-frame support brackets (both sides)
- Lowering the sub-frame
- Draining the transmission fluid
- Removing the control system cover
- Removing the cable harness
- Checking The Solenoids
- Assembling the control system
- Installing the sub-frame and front suspension components
- Installing the sub-frame
- Installing components in the steering gear and sub-frame
- Installing the nuts securing the ball joint to the control arm and the anti-roll bar to the link rods
- Installing the collision protection system over the steering gear (right-hand drive cars)
- Installing the bracket for the heated oxygen sensor (HO2S)
- Installing the screw for the drive shaft
- Installing components on the sub-frame
- Installing the splash guard under the engine
- Removing lifting beams and the lifting hook
- Assembling the connectors
- Installing connectors and wiring
- Installing the air cleaner (ACL) housing and connections
- Resetting Transmission fluid change counter