Checking the tilt sensor
Check the rear electronic module connector and the tilt sensor connector for defects and an open-circuit.
Check the ground connection between tilt sensor connector terminal #5 and ground terminal 31/72. Check the cable and connector in the cable harness between these two points. See Open-circuit, permanent faults and Open-circuit, intermittent faults .
Other information
- For information about signals:
- For MY -2003, see Signal specification
- For MY 2004, see Signal specification
- To connect the breakout box, see Connecting the breakout box .
Was a fault detected?
- YES
Refer to Verifying sensors
- NO
Refer to Replacing sensors