Install the Wheel

Fig 1: Identifying Wheel Installation

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that the brake disc and wheel rim mating surfaces are clean. Lubricate the center guide for the hub. Use rustproofing agent P/N 1161038-3. Position the wheel and lightly tighten the nuts.

Then tighten crosswise. Tighten to 110 Nm .

When tightening using an impact wrench, torque socket 9512834 must be used.

Post tighten the nuts by hand.

CAUTION: The correct tightening torques and crosswise tightening for the nuts are essential to avoid stresses in the brake disc.

Install the hub cap.